Fencing — Parkside 5063
Parkside Fencing, SA 5063
Parkside is about 2.4 km south-east of the Adelaide CBD, and the work here is scoped from what the site actually shows. This page explains the fencing process for Parkside, from setting out to the finished job. The ground at Parkside is recorded as reactive clay over the inner-south plain, seasonally reactive, and the terrain as ground that is flat and rises gently toward the parklands edge.
Common in Parkside
What to expect on a Parkside block
The same handful of problems turn up again and again on this kind of work. Each one changes the scope, and each is priced as its own line rather than buried in a rate.
01
A fence leaning because the posts were set shallow
02
Panels that have racked out of square on a slope
03
A boundary where the two sides cannot agree on height or cost
04
Gates that have dropped and no longer latch
05
Old fencing that was never taken away and disposed of
What Parkside is built on
What the Parkside site visit looks at
Parkside is 2.4 km south-east of the Adelaide CBD and inside the 60 km service area. The ground is recorded as reactive clay over the inner-south plain, seasonally reactive, with ground that is flat and rises gently toward the parklands edge, so what is in the post line and how deep the posts have to go decide whether the fence stays straight. Access to the work area, what sits under the existing surface, and how the block drains are all checked at the address before anything is priced.
How it goes
From first cut to handover in Parkside
Every job follows the same sequence, and the sequence is what makes the finished work hold up. Timber paling and capped picket fences, Colorbond, aluminium and timber slat screens, and gates that hang true and keep working. Posts are set in concrete at depths matched to fence height and the ground, and old fencing is removed and disposed of.
01
The old fence comes down and the materials are carted off
02
String lines go up and post positions are marked at even centres
03
Post holes are bored to depth along the line
04
Posts are set in concrete, plumbed and braced
05
Rails and cladding are fixed straight and level
06
Capping and gates go on and the gate is checked for swing
Why AOI
The same team scopes and builds it
Fencing at Parkside is priced from a written scope that lists what is included before anything is cut, dug or poured. The same team that scopes the work builds it, so the plan that is approved is the plan that gets built.
On price
Quotes for Parkside
A written quote follows the site visit at Parkside. It sets out the scope line by line so you can see what is included, and anything found on site that sits outside the scope is quoted and approved before it is touched.
Questions from Parkside
Fencing in Parkside — FAQs
Do you cover Parkside for fencing?
Parkside 5063 is covered, about 2.4 km south-east of the city centre and well inside 60 km. Quoting begins with a visit.
How deep should fence posts go?
Depth target is one third of the fence height, minimum 600 mm, concreted in. The reactive clay over the inner-south plain here is seasonally active, so we allow extra. Post depth is the only element that cannot be fixed without a rebuild.
Can a fence sit on top of a retaining wall?
Yes, where a wall already holds the level. Posts either descend through the wall or stand on plinths so the fence ties into it, and wall and fence are built as a single scope.
What height can a fence be?
Fences go to council's no-approval height; anything taller or within a heritage or character overlay is checked before building. Height is settled during quoting.
Fencing near Parkside
Ready to start in Parkside?
Book a free site visit in Parkside. The fixed written quote follows the visit.